LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Fuel System) >> Fuel Injection >> Throttle Body >> Installation >> Throttle Body - 2.4L Turbo

Throttle Body - 2.4L Turbo

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Throttle Body Gasket- 2.4L Turbo
GC0021673Courtesy of CHRYSLER LLC
  1. Discard old gasket and clean intake manifold surface.
    Fig 2: Throttle Body - 2.4L Turbo
    GC0021672Courtesy of CHRYSLER LLC
  2. Install the throttle body.
    Fig 3: Throttle Body Bolts - 2.4L Turbo
    GC0021671Courtesy of CHRYSLER LLC
  3. Install the 3 bolts to the throttle body and tighten to 12 ±2.25 N.m (105 in. lbs.).
  4. Connect the purge hose to the throttle body.
  5. Connect the throttle body inlet hose to the throttle body and tighten clamp.
    Fig 4: Throttle Cables
    GC0021675Courtesy of CHRYSLER LLC
  6. Install bracket.
  7. Install the 2 screws for the throttle cable bracket and tighten to N.m 12 ±2.25 (105 in. lbs.).
  8. If equipped with speed control, install speed control cable to the throttle cam by sliding clasp in the hole used for throttle cable.
  9. Install the throttle cable to the throttle body cam.
    Fig 5: Throttle Control Shield - 2.4L Turbo
    GC0021640Courtesy of CHRYSLER LLC
  10. Install the throttle control shield.
  11. Connect and lock the electrical connectors from the idle air control motor and throttle position sensor.
  12. Connect and lock the electrical connector for the inlet air temperature sensor.
  13. Connect the negative battery cable.
scientia non olet · About LEMON Manuals