Crankshaft Position Sensor - 2.0, 2.4, 2.4L Turbo

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Crankshaft Position Sensor

Courtesy of CHRYSLER LLC

The Crankshaft Position Sensor is in the front of the engine block just under the starter motor.

Disconnect the negative battery cable.
Raise vehicle and support.

Fig 2: Crankshaft Position Sensor - 2.4 L Turbo
Courtesy of CHRYSLER LLC
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor.