Installation - 2.0, 2.4, 2.4L Turbo
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Check O-ring for damage and lubricate the O-ring with engine oil before installing sensor.
- Use a twisting motion when installing the sensor.
- Install and tighten the crankshaft position sensor bolt and tighten to 9 N.m (80 ±15 in. lbs.).
- Connect and lock the electrical connector to the crankshaft position sensor.
- Lower vehicle.
- Connect the negative battery cable.