LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Fuel System) >> Fuel Injection >> Injectors-Fuel >> Removal >> Fuel Injector - 2.0, 2.4L

Fuel Injector - 2.0, 2.4L

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuel Injector & Fuel Rail Location
GC0021627Courtesy of CHRYSLER LLC
1 - FUEL INJECTOR
2 - FUEL TEST PORT
WARNING: Release fuel system pressure before servicing fuel system components. Service vehicles in well ventilated areas and avoid ignition sources. Never smoke while servicing the vehicle. This may result in personal injury or death.
  1. Release fuel system pressure, see STANDARD PROCEDURE .
  2. Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
  3. Remove the negative battery cable.
  4. Remove the engine cover or throttle control shield if equipped.
    NOTE: Wrap shop towels around hose to catch any gasoline spillage.
  5. Disconnect fuel supply tube from rail. Refer to QUICK-CONNECT FITTINGS .
  6. Remove the Intake Manifold, refer to MANIFOLD-INTAKE .
  7. Disconnect electrical connectors from fuel injectors.
  8. Remove bolts holding fuel rail.
  9. Remove the fuel rail and injectors.
  10. Remove injectors from the fuel rail.
scientia non olet · About LEMON Manuals