LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Fuel System) >> Fuel Delivery >> Tube-Fuel Tank Filler >> Removal >> Fuel Filler Neck

Fuel Filler Neck

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuel Filler Cap
GC0021648Courtesy of CHRYSLER LLC
  1. Remove the air cleaner lid and makeup air hose.
  2. Remove the negative battery cable.
  3. Loosen fuel filler tube cap.
    Fig 2: Removing/Installing Fuel Filler Neck
    GC0021649Courtesy of CHRYSLER LLC
  4. Remove fuel filler neck screws.
    Fig 3: Splash Shield
    GC0021650Courtesy of CHRYSLER LLC
    1 - SPLASH SHIELD
  5. Raise vehicle and support.
  6. Remove the right rear wheel.
  7. Remove the rear half of the inner splash shield (1).
    NOTE: Drain fuel tank if it is more than half full.
    Fig 4: Filler Tube
    GC0021651Courtesy of CHRYSLER LLC
    1 - VAPOR RECIRCULATION TUBE
    2 - FILLER TUBE
  8. Disconnect fuel filler tube hose from fuel tank neck. Remove fuel filler tube assembly (2).