Diagnostic Test

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

1) IAC MOTOR OPERATION
NOTE: If the engine will not idle, maintain an engine speed between 800 and 1500 RPM.

Start the engine.

Allow the engine to idle.

With a scan tool, read the IAC Current.

Is the IAC Current above 999 mA?

Yes
1. Go to 2).
No
1. Refer to the INTERMITTENT CONDITON Diagnostic Procedure.
2. Perform POWERTRAIN VERIFICATION TEST .
2) IAC MOTOR
Turn the ignition off.

Disconnect the IAC Motor harness connector.

With the scan tool, monitor the IAC Current.

Ignition on, engine not running.

Does the scan tool display IAC Current at 0mA?

Yes
1. Replace the IAC Motor.
2. Perform POWERTRAIN VERIFICATION TEST .
No
1. Go to 3).
3) (K961) IAC SIGNAL CIRCUIT SHORTED TO BATTERY VOLTAGE

Fig 1: Measuring For Voltage On IAC Signal Circuit
Courtesy of CHRYSLER LLC

Turn the ignition off.

Disconnect the C2 PCM harness connector.

Ignition on, engine not running.

Measure the voltage on the (K961) IAC Signal circuit in the IAC Motor harness connector.

Is the voltage above 0.5 of a volt?

Yes
1. Repair the short to battery voltage in the (K961) IAC Signal circuit.
2. Perform POWERTRAIN VERIFICATION TEST .
No
1. Go to 4).
4) (K61) IAC MOTOR CONTROL CIRCUIT SHORTED TO BATTERY VOLTAGE

Fig 2: Measuring For Voltage On IAC Motor Control Circuit
Courtesy of CHRYSLER LLC

Turn the ignition off.

Measure the voltage on the (K61) IAC MOTOR CONTROL circuit in the IAC Motor harness connector.

Is the voltage above 0.5 of a volt?

Yes
1. Repair the short to battery voltage in the (K61) IAC MOTOR CONTROL circuit.
2. Perform POWERTRAIN VERIFICATION TEST .
No
1. Go to 5).
5) (K61) IAC MOTOR CONTROL CIRCUIT SHORTED TO THE (K961) IAC RETURN CIRCUIT

Fig 3: Measuring Resistance Across IAC Signal Circuit & IAC Motor Control Circuit
Courtesy of CHRYSLER LLC

Measure the resistance across the (K961) IAC Signal circuit and the (K61) IAC MOTOR CONTROL circuit in the IAC Motor harness connector.

Is the resistance below 5.0 ohms?

Yes
1. Repair the short between the (K961) IAC Signal circuit and the (K61) IAC MOTOR CONTROL circuit.
2. Perform POWERTRAIN VERIFICATION TEST .
No
1. Go to 6).
6) PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage or terminal push out. Repair as necessary.

Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.

Were there any problems found?

Yes
1. Repair as necessary.
2. Perform POWERTRAIN VERIFICATION TEST .
No
1. Replace and program the Powertrain Control Module per Service Information.
2. Perform POWERTRAIN VERIFICATION TEST .