Reservoir, 1.6L
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - RETURN HOSE |
| 2 - FLUID RESERVOIR |
| 3 - SUPPLY HOSE |
| 4 - 1.6L ENGINE |
| 5 - COOLER OUTLET TUBE |
| 6 - PRESSURE HOSE |
- Align the guide on the rear of the reservoir (2) with the mounting bracket and push reservoir downward until reservoir clicks into place in the bracket.
- Install the supply hose (3) onto the bottom of the reservoir. Slide the hose clamp into position on the fluid reservoir and attach it. Be sure hose clamp in installed past bead on fluid reservoir fitting.
- Install the return hose (1) onto the reservoir. Slide the hose clamp into position on the fluid reservoir and attach it. Be sure hose clamp in installed past bead on fluid reservoir fitting.
- Fill the fluid reservoir to the proper level. See STANDARD PROCEDURE .
- Start the engine and let run for a few seconds, then turn the engine off.
- Add fluid as necessary.
- Install the filler cap.