Pulley-Pump, 2.2L Diesel
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - PULLEY MOUNTING BOLTS |
| 2 - RIGHT FRAME RAIL |
| 3 - PRESSURE HOSE FITTING |
| 4 - PULLEY |
- Install the pump drive pulley (4). Install and tighten the three mounting bolts (1) to 28 N.m (21 ft. lbs.).
- Install accessory drive belt. Refer to INSTALLATION
.
1 - ENGINE COMPARTMENT SILENCER 2 - ACCESSORY DRIVE BELT SPLASH SHIELD - Install the lower engine compartment silencer assembly (1) and the drive belt splash shield (2).
- Lower the vehicle.