Hose-Supply, 2.4L

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, see WARNING .

Siphon as much fluid as possible from the power steering fluid reservoir.

Fig 1: Identifying Grille Attachment
Courtesy of CHRYSLER LLC

1 - GRILLE

2 - RETAINER
Remove the grille (1) from the front of the vehicle. Refer to REMOVAL .
Remove the hood-opening weather-strip from across the radiator closure panel.

Fig 2: Ambient Temperature Sensor
Courtesy of CHRYSLER LLC

1 - FASTENER

2 - SENSOR
Remove the fastener (1), then the ambient temperature sensor (2) from the radiator closure panel.

Fig 3: Identifying Radiator Closure Panel
Courtesy of CHRYSLER LLC

1 - FASTENERS
Remove the fasteners (1) securing the upper radiator closure panel in place, then remove the panel.

Fig 4: Supply Hose At Pump
Courtesy of CHRYSLER LLC

1 - SUPPLY HOSE CLAMP

2 - POWER STEERING PUMP

Remove the clamp (1) securing the supply hose to the power steering pump (2) supply fitting, then remove the hose from the supply fitting.

Fig 5: Identifying Hose Connection At Reservoir

Courtesy of CHRYSLER LLC

1 - POWER STEERING FLUID RESERVOIR

2 - ENGINE COVER

3 - SUPPLY HOSE

4 - RETURN HOSE

Remove the hose clamp securing the supply hose (3) to the power steering fluid reservoir (1). Slide the hose off the end of the reservoir fitting and remove from vehicle.