LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (6.1L Engine (Service Information)) >> Retainer-Crank Rear Oil - Seal >> Installation

Retainer-Crank Rear Oil - Seal: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seal Retainer Torque Sequence
GC0003976Courtesy of DAIMLERCHRYSLER CORP.
  1. Thoroughly clean all gasket residue from the engine block.
  2. Use extreme care and clean all gasket residue from the retainer.
  3. Position the gasket onto the retainer.
  4. Position the retainer onto the engine block.
  5. Install the retainer mounting bolts. Tighten the bolts to 15 N.m (132 in. lbs.) using the procedure shown.
  6. Install the oil pan. (Refer to ENGINE/LUBRICATION/OIL PAN - INSTALLATION) 
  7. Install the flexplate. (Refer to ENGINE/ENGINE BLOCK/FLEX PLATE - INSTALLATION) .
  8. Install the transmission. Refer to appropriate SERVICE INFORMATION article.
  9. Check and verify engine oil level.
  10. Start engine and check for leaks.
scientia non olet · About LEMON Manuals