LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (6.1L Engine (Service Information)) >> Manifold - Intake >> Installation >> Installation

Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position intake manifold.
  2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 124 N.m (124 in. lbs.).
  3. Connect electrical connectors for the following components:
    1. Manifold Absolute Pressure (MAP) Sensor
    2. Fuel Injectors
    3. ETC ( Electronic Throttle Control )
  4. Connect Brake booster hose, purge hose, and MUA hose (Make Up Air hose).
  5. Install air inlet hose.
  6. Connect negative cable to battery.
  7. Install engine covers. See Figure.
scientia non olet · About LEMON Manuals