Assembly-Wire Harness
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Position the convertible top in the raised position.
- Remove the rear seat cushion. See REMOVAL .
- Remove the left interior quarter trim panel. See REMOVAL .
- Remove the rear seat back. See REMOVAL .
- Remove the push-pins (1) that secure the convertible top well (2) to the rear seat back panel (3) and body (4) and remove the well liner.
- Remove the protective cover (3) from the top of the hydraulic pump/motor assembly (4) located on the shelf panel (2).
- Disconnect the wire connector for the pump motor (1).
- Remove the three retaining clips that secure the convertible top wire harness (3) and relay (2) to the body.
- Disconnect the two wire harness connectors from the rear window defogger terminals and route the defogger wire harness lead (1) through the wire slings.
- Disconnect the convertible top wire harness connector (2) from the body wire harness (3) located on the left side of the vehicle and remove the convertible top wire harness.