LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Message Center (Service Information)) >> Message Center >> HOMELINK Transceiver >> Standard Procedure >> Erasing Transmitter Codes

Erasing Transmitter Codes

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.

To erase programming from the three buttons (individual buttons cannot be erased but only "reprogrammed"), follow the step noted:

  1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. All HomeLink® channels are now erased/cleared.
scientia non olet · About LEMON Manuals