Fog Lamp Unit Alignment

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Prepare an alignment screen. See STANDARD PROCEDURE . and read the Alignment Screen Preparation paragraph. Turn on the headlamp switch to the parking lamps only position and actuate the fog lamp switch. A properly aligned fog lamp will project a pattern on the alignment screen with the top of the cut-off line 10 cm (4 in.) below the fog lamp center line and straight ahead with the vehicle 25 feet from the alignment screen.

Fig 1: Fog Lamp Unit Alignment Screen

Courtesy of CHRYSLER LLC

ALIGNMENT SCREEN SET-UP

1 - CENTER LINE OF FOG LAMPS	5 - FOG LAMP HOT SPOT
2 - CENTER LINE OF VEHICLE	6 - FRONT OF FOG LAMP
3 - FLOOR TO CENTER OF FOG LAMP	7 - 7.62 METERS (25 FT.)
4 - 10cm (4 IN.)

Fig 2: Identifying Fog Lamp Adjusting Screw

Courtesy of CHRYSLER LLC

To adjust fog lamp unit, rotate the adjustment screw (1) in the rear of the fog lamp unit to achieve the specified pattern position. It will be necessary to remove the lower splash shield to do this. Refer to REMOVAL .