LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (5.7L Engine (Service Information)) >> Sensor-Oil Pressure >> Removal

Sensor-Oil Pressure: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the accessory drive belt (Refer to DRIVE BELT )
  3. Remove the upper generator mounting bolt.
  4. Raise and support the vehicle.
  5. Remove the lower splash shield retaining bolts (1) and the splash shield.
    G00585679Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the lower generator retaining bolts (1).
    G00585680Courtesy of DAIMLERCHRYSLER CORP.
  7. Lower the vehicle.
  8. Position the generator aside to gain access to the oil pressure sensor.
  9. Disconnect the oil pressure sensor electrical connector (1).
    G00585681Courtesy of DAIMLERCHRYSLER CORP.
  10. Remove the oil pressure sensor (1).
    G00585682Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals