LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (5.7L Engine (Service Information)) >> Removal >> Installation >> Exhaust Manifold

Exhaust Manifold

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exhaust Manifold Bolt Tightening Sequence - Left
GC0004014Courtesy of DAIMLERCHRYSLER CORP.
Fig 2: Exhaust Manifold Bolt Tightening Sequence - Right
GC0004013Courtesy of DAIMLERCHRYSLER CORP.
  1. Install manifold gasket and manifold.
  2. Install manifold bolts and tighten to 25 N.m (18 ft. lbs.).
  3. Install heat shield and tighten nuts to 8 N.m (70 in. lbs.).
    Fig 3: Engine Hydromount LH
    GC0015463Courtesy of DAIMLERCHRYSLER CORP.
    1 - Bolt
    2 - Hydromount
    3 - Studs
    Fig 4: Engine Hydromount RH
    GC0015462Courtesy of DAIMLERCHRYSLER CORP.
    1 - Studs
    2 - Nut
    3 - Hydromount
    4 - Studs
  4. Install engine mounts (3). (Refer to ENGINE/ENGINE MOUNTING/FRONT MOUNT - INSTALLATION) 
  5. Lower engine.
    CAUTION: Do not damage engine harness while lowering the engine.
  6. Install and tighten right and left side engine mount to frame fasteners (4) (Refer to ENGINE/ENGINE MOUNTING/FRONT MOUNT - INSTALLATION) .
  7. Install exhaust flange to pipe bolts.
  8. Lower vehicle.
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals