Ignition Coil -2.4L Turbo

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Ignition Coil

Courtesy of CHRYSLER LLC

Install the coil on throttle body side of the intake manifold, rotate down past the throttle body to the valve cover. See Figure.

Fig 2: Removing/Installing Ignition Coil
Courtesy of CHRYSLER LLC
Rotate coil pack and install under intake manifold.

Fig 3: Ignition Coil Bolt
Courtesy of CHRYSLER LLC
Install bolts to ignition coil. Twist coil to install 2 of the bolts.
Install coil pack on valve cover. Tighten the bolts to 12 N.m (105 in. lbs.).
Install the spark plug cables to the ignition coil.
Connect and lock the electrical connector to the ignition coil.

Fig 4: Throttle Cable Bracket
Courtesy of CHRYSLER LLC
Install the throttle cable bracket. See Figure.

Fig 5: Throttle Cables
Courtesy of CHRYSLER LLC
Install the throttle cables to the throttle body lever. See Figure.

Fig 6: Throttle Control Shield
Courtesy of CHRYSLER LLC
Connect the negative battery cable.
NOTE: Check and make sure that throttle body and attachments will not contact ignition cables.
Install the throttle control shield. See Figure.