LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Ignition System (Service Information)) >> Ignition Control >> Coil-Ignition >> Installation >> Ignition Coil - 1.6L

Ignition Coil - 1.6L

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rubber Insulators & Ignition Coil
GC0019925Courtesy of CHRYSLER LLC
1 - RUBBER ISOLATORS_1
2 - COIL_2
  1. Install coil and insulators and tighten bolts to 12 N.m (105 in. lbs.).
    Fig 2: Installing Gasket To Upper Intake Manifold
    GC0022908Courtesy of CHRYSLER LLC
  2. Install gasket to upper intake manifold.
    Fig 3: Upper Intake Gasket Positioning
    GC0022909Courtesy of CHRYSLER LLC
  3. Install the 4 bolts from the upper to lower manifold and tighten to 12 N.m (105 in. lbs.).
  4. Install the 2 bolts to the upper manifold to struts and tighten to 19 N.m (165 in. lbs.).
  5. Install the PCV hose and the brake booster hose to the upper manifold.
  6. Install the purge hose to throttle body.
  7. Connect the electrical connector to throttle body.
  8. Connect the negative battery cable.
  9. Install air cleaner assembly cover and connect the inlet air temperature sensor. See Figure.
scientia non olet · About LEMON Manuals