Pump - Oil: Assembly
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - OIL PUMP BODY |
| 2 - OIL PUMP OUTER ROTOR |
| 3 - SCREWS |
| 4 - OIL PUMP COVER |
| 5 - OIL PUMP INNER ROTOR |
- Assemble oil pump using new parts as required.
- Tighten cover screws (3) to 12 N.m (105 in. lbs.). See Fig 1.
- Prime oil pump before installation by filling rotor cavity with engine oil.
- If oil pressure is low and pump is within specifications, inspect for worn engine bearings or other reasons for oil pressure loss.