Mount - Right: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Right Engine Mount Heat Shield

Courtesy of DAIMLERCHRYSLER CORP.

1 - BOLT

2 - SHIELD

3 - RIGHT ENGINE MOUNT

Disconnect the negative battery cable.
Raise and support the vehicle.
Remove both of the engine mount to cradle nuts.
Remove both of the engine mount through studs.
Using a suitable jack stand and a block of wood positioned under the oil pan, raise the engine until the weight is off of the mounts (approximately 5 mm.).
Remove the right mount heat shield (2) bolts. See Fig 1.

Fig 2: Right Engine Mount
Courtesy of DAIMLERCHRYSLER CORP.

1 - BOLT

2 - RIGHT ENGINE MOUNT
Remove the engine mount (2). See Fig 2.