Housing-Air Cleaner: Installation
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BOLT |
| 2 - CCV HOSE |
| 3 - THROTTLE |
| 4 - IAT SENSOR |
| 5 - INLET AIR DUCT |
| 6 - AIR CLEANER ELEMENT HOUSING |
- Align the housing (6) with the lower air inlet duct and alignment grommet in the wheel housing.
- Properly fit the housing (6) and install housing retaining bolt (1). See Fig 1.
- Connect the inlet air duct (5) to the housing (6) and tighten clamp.
- Connect the CCV hose (2) to housing.