Cover Cylinder Head - Right: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Coils - Right Cylinder Head

Courtesy of DAIMLERCHRYSLER CORP.

1 - FUEL RAIL

2 - IGNITION COIL

3 - CAPACITOR

4 - ENGINE WIRING HARNESS

WARNING: DO NOT START OR RUN ENGINE WITH CYLINDER HEAD COVER REMOVED FROM THE ENGINE. DAMAGE OR PERSONAL INJURY MAY OCCUR.

Disconnect the negative battery cable.
Remove the upper intake manifold. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) .
Cover lower intake manifold openings during service.
Disconnect and remove the three ignition coils (2).
Lift up on the wire harness track retaining tabs (4).
Remove the ground strap retaining bolt (3) from the cylinder head cover.
Completely loosen the cylinder head cover retaining bolts and remove the cylinder head cover.