LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (3.5L Engine (Service Information)) >> Bearing - Connecting Rod >> Standard Procedure >> Connecting Rods And Bearings >> Connecting Rod Bolts

Connecting Rod Bolts

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Check for Stretched Bolts
GC0001879Courtesy of DAIMLERCHRYSLER CORP.
1 - STRETCHED BOLT
2 - THREADS ARE NOT STRAIGHT ON LINE
3 - THREADS ARE STRAIGHT ON LINE
4 - UNSTRETCHED BOLT
  1. Examine connecting rod bolts for stretching (1). Stretching (1) can be checked by holding a scale or straight edge against the threads. If all the threads do not contact the scale the bolt must be replaced.
  2. Before installing the bolts the threads should be cleaned and inspected.
  3. Install clean bolts finger tight. Then alternately torque each bolt to assemble the cap properly.
  4. Tighten the connecting rod cap bolts to specification. (Refer to ENGINE - SPECIFICATIONS) .
scientia non olet · About LEMON Manuals