LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Engine & Automatic Transmission Cooling System) >> Engine >> Thermostat-Engine Coolant >> Installation >> Installation-1.6L

Thermostat-Engine Coolant: Installation: Installation-1.6L

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Thermostat Orientation
GC0021811Courtesy of CHRYSLER LLC
1 - ALIGN AIR BLEED WITH NOTCH IN THERMOSTAT HOUSING
2 - THERMOSTAT SEAL
3 - THERMOSTAT HOUSING
  1. Clean all sealing surfaces.
  2. Place thermostat and seal (2) into thermostat housing. Align air bleed with notch in thermostat housing.
  3. Install thermostat housing and fasteners. Torque fasteners to 7 N.m (65 in. lbs.).
  4. Connect upper radiator hose and heater hose to thermostat housing.
  5. Install fasteners securing heater return tube to engine block and thermostat housing.
  6. Install battery.
  7. Connect positive battery cable.
  8. Connect negative battery cable.
  9. Fill cooling system, refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals