Removal-2.2L Diesel Engine
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - FUEL RAIL |
| 2 - EGR VALVE |
| 3 - POWER STEERING PUMP |
| 4 - GENERATOR |
| 5 - COOLANT TEMPERATURE SENSOR |
| 6 - THERMOSTAT HOUSING |
| 7 - FUEL RAIL PRESSURE SENSOR |
- Disconnect negative battery cable.
- Remove engine cover.
- Partially drain coolant system below pressurized coolant recovery container. See STANDARD PROCEDURE .
- Unplug coolant temperature sensor (5) electrical connector.NOTE: Capture any residual coolant that may flow.
- Remove coolant temperature sensor (5).