Slave Cylinder - 1.6/2.4L

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hydraulic Tube Retaining Clips

Courtesy of CHRYSLER LLC

1 - RETAINER CLIPS

Connect slave cylinder to hydraulic tube. Press both retainer clips (1) to secure tube in cylinder. See Fig 1.

Fig 2: Clutch Slave Cylinder At Transaxle - 1.6L+C1550
Courtesy of CHRYSLER LLC

1 - SLAVE CYLINDER

2 - BOLT

Fig 3: Clutch Slave Cylinder At Transaxle - 2.0L & 2.4L
Courtesy of CHRYSLER LLC

1 - SLAVE CYLINDER

2 - BRACKET
Install the slave cylinder assembly (1) into position on transaxle. See Fig 2 and Fig 3.
Tighten slave cylinder-to-transaxle bolts to 19 N.m (168 in. lbs.) on 2.4L applications and 12 N.m (105 in. lbs.) torque on 1.6L applications.
Lower vehicle.
Verify brake master cylinder reservoir is full. Top off with DOT 3 brake fluid if necessary.
Bleed clutch hydraulic system. See STANDARD PROCEDURE .
Verify proper clutch release system operation.