LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Suspension System) >> Rear Suspension >> Link-Watts >> Removal >> Link-Watts, Lower

Link-Watts, Lower

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding, see WARNING .
  1. Raise and support the vehicle. Refer to STANDARD PROCEDURE .
    Fig 1: Exploded View Of Watts Linkage System
    GC0043361Courtesy of CHRYSLER LLC
  2. Remove the nut (1) securing the bell crank pivot bolt in the center of the axle (11).
  3. With the bolt (7) still installed, slide the bell crank (9) away from the axle just enough to allow removal of the nut (10) securing the lower link to the bell crank.
  4. Remove the nut (10) securing the link ball joint to the bell crank (9).
  5. Install Remover, Special Tool MB991113, on the link (8) ball joint at the bell crank and release the ball joint from the bell crank.
    Fig 2: Watts Link To Body Attaching Points
    GC0043370Courtesy of CHRYSLER LLC
  6. Remove the bolt (6) securing the link (5) to the body bracket (4). See Fig 2.
  7. Remove the lower link.
scientia non olet · About LEMON Manuals