LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Windage Tray >> Removal

Windage Tray: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative battery (1) cable located in the trunk.
  2. Raise vehicle.
    Fig 2: Lower Splash Shield
    GC0015233Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove lower splash shield retaining bolts (1) and splash shield (2).
    Fig 3: Locating Engine Mount Bolts, Drain Plug And Filter
    GC0015226Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove oil filter (3).
  5. Remove oil pan (4) (Refer to ENGINE/LUBRICATION/OIL PAN - REMOVAL) .
    Fig 4: Windage Tray
    GC0015320Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove oil pump pickup tube (2).
  7. Remove windage tray/outer main bearing cap bolts (3).
  8. Remove windage tray (1).
scientia non olet · About LEMON Manuals