LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Rings-Piston >> Standard Procedure >> Standard Procedure - Piston Ring Fitting

Standard Procedure - Piston Ring Fitting

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Check Gap on Piston Rings
GC0015338Courtesy of DAIMLERCHRYSLER CORP.
  1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore. The ring gap measurement must be made with the ring positioning at least 12 mm (0.50 inch.) from bottom of cylinder bore. Check gap with feeler gauge (1). Refer to ENGINE - SPECIFICATIONS  for clearance measurements.
    Fig 2: Measuring Piston Ring Side Clearance
    GC0015339Courtesy of DAIMLERCHRYSLER CORP.
  2. Check piston ring to groove clearance with feeler gauge (1). For clearance specifications refer to ENGINE - SPECIFICATIONS .
scientia non olet · About LEMON Manuals