LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Manifold-Exhaust >> Removal >> Right Exhaust Manifold

Right Exhaust Manifold

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: Right Exhaust Manifold
    GC0015377Courtesy of DAIMLERCHRYSLER CORP.
  2. Disconnect and remove upstream oxygen sensor (5).
  3. Raise vehicle.
  4. Remove EGR tube at EGR valve (1).
  5. Remove EGR tube at manifold (4).
  6. Disconnect down stream oxygen sensor electrical connector.
  7. Disconnect exhaust pipe from manifold (4) (Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - REMOVAL) .
  8. Remove upper heat shield (2) and lower heat shield (3).
  9. Remove manifold attaching bolts and remove manifold.
scientia non olet · About LEMON Manuals