LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Cover(S)-Cylinder Head >> Removal >> Right

Cover(S)-Cylinder Head: Removal: Right

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative battery (1) cable.
    Fig 2: Coil Connectors
    GC0015236Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove upper intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) .
  3. Disconnect electrical connectors from ignition coils (1).
    Fig 3: Capacitor Connector - Right
    GC0015302Courtesy of DAIMLERCHRYSLER CORP.
  4. Disconnect capacitor electrical connector (2).
  5. Remove PCV hose from cylinder head cover grommet.
  6. Remove ground strap from cylinder head cover stud (1).
  7. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
  8. Remove fastener attaching ignition coil capacitor.
  9. Remove ignition coils.
    Fig 4: Foam Insulator
    GC0015303Courtesy of DAIMLERCHRYSLER CORP.
  10. Remove foam insulator (1).
    Fig 5: Cylinder Head Covers
    GC0015300Courtesy of DAIMLERCHRYSLER CORP.
  11. Loosen all cylinder head cover fasteners.
    NOTE: Cylinder head cover attaching bolts are captured to the cover.
    CAUTION: Make certain the double ended studs in the center of the cylinder head cover are loose before attempting to remove cover.
  12. Remove cylinder head cover.
scientia non olet · About LEMON Manuals