LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Cover(S)-Cylinder Head >> Installation >> Right

Cover(S)-Cylinder Head: Installation: Right

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover Gasket and Spark Plug Seals
GC0015298Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1)&(2) as necessary.
    Fig 2: Cylinder Head Covers
    GC0015300Courtesy of DAIMLERCHRYSLER CORP.
  2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
  3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 N.m (105 in. lbs.).
    Fig 3: Coil Connectors
    GC0015236Courtesy of DAIMLERCHRYSLER CORP.
  4. Install ignition coils (1).
    Fig 4: Capacitor Connector - Right
    GC0015302Courtesy of DAIMLERCHRYSLER CORP.
  5. Install ignition coil capacitor (2) and fastener.
  6. Connect ground strap (1) to cylinder head cover stud.
  7. Connect PCV hose to cylinder head cover grommet.
  8. Connect all electrical connectors and harness clips.
    Fig 5: Foam Insulator
    GC0015303Courtesy of DAIMLERCHRYSLER CORP.
  9. Install foam insulator (1) on top of cylinder head cover (2).
  10. Install upper intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) .
    Fig 6: Locating Battery
    GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  11. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals