LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Collar-Structural >> Removal

Section 15 (2.7L Engine (Service Information)): Collar-Structural: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: Lower Splash Shield
    GC0015233Courtesy of DAIMLERCHRYSLER CORP.
  2. Raise vehicle on hoist.
  3. Remove lower splash shield retaining bolts (1) and splash shield (2).
    Fig 3: Remove Trans Mount
    GC0015330Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove transmission mount bolts (2).
  5. Place a transmission jack under the transmission pan and raise engine and transmission.
    Fig 4: Locating Structural Collar Bolts
    GC0015227Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove bolts attaching structural collar to oil pan (3) and transmission bell housing (4).
    Fig 5: Remove Structural Collar
    GC0015345Courtesy of DAIMLERCHRYSLER CORP.
  7. Move structural collar (1) to the right.
  8. Remove structural collar (1) out towards the rear.
scientia non olet · About LEMON Manuals