Park/Turn Signal Lamp: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Remove headlamp access cover in splash shield. See Figure.
Rotate socket counterclockwise one quarter turn.
Remove bulb and socket from headlamp unit.
Disconnect wire connector from back of front side marker/park/turn signal lamp. See Fig 1

Fig 1: Headlamp Access

Courtesy of DAIMLERCHRYSLER CORP.

1 - HIGH BEAM LAMP

2 - LOW BEAM LAMP

3 - PARK/TURN SIGNAL LAMP