LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Lighting Systems - Exterior (Service Information)) >> Front Position Lamp - Export >> Diagnosis And Testing

Diagnosis And Testing

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Battery must be completely charged (12v) prior to testing. It may also be necessary to install battery charger on the vehicles electrical system when performing this test.
  1. Remove the front position lamp bulb and check for burned out condition. Replace bulb if necessary.
  2. If bulb appears OK, reinstall the bulb in its socket and rotate the left side multi-function switch one detent position and check for lamp operation. If lamp is still inoperative proceed to next step.
  3. Remove lamp bulb and check for power (12v) and ground connections in lamp socket. If power and/or ground connections are not present, trace wire until open or short is found. Refer to SYSTEM WIRING DIAGRAMS for a complete system schematic. Refer to the appropriate diagnostic information.
scientia non olet · About LEMON Manuals