LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Lighting Systems - Exterior (Service Information)) >> Brake Lamp Switch >> Removal

Brake Lamp Switch: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unclip the air cleaner cover (two clips) and move the cover aside.
  2. Disconnect and isolate the battery negative cable from its post on the battery.
  3. Remove the silencer pad below the knee blocker.
  4. Fold down and remove the knee blocker below the steering column.
  5. Remove the brake lamp switch from its bracket by rotating the switch in a counterclockwise direction approximately 30 degrees, then pulling the switch rearward.
  6. Disconnect the wiring harness connector.
  7. Discard the brake lamp switch. It must not be reused. 
scientia non olet · About LEMON Manuals