Seal-Rear Output Shaft: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Output Shaft Nut

Courtesy of DAIMLERCHRYSLER CORP.

1 - HOLDER 6958

2 - REAR OUTPUT SHAFT FLANGE

Remove the rear propeller shaft. (Refer to DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT - REMOVAL)
Using Holder 6958 (1), remove the rear output shaft flange (2) nut. See Fig 1.

Fig 2: Remove Rear Output Shaft Flange
Courtesy of DAIMLERCHRYSLER CORP.

1 - PULLER

2 - REAR OUTPUT SHAFT FLANGE
Using a suitable 2 or 3 jaw puller (1), remove the rear output shaft flange (2). See Fig 2.

Fig 3: Remove Rear Output Shaft Seal
Courtesy of DAIMLERCHRYSLER CORP.

1 - SEAL

2 - TRANSFER CASE

3 - PRY TOOL
Using a suitable pry tool (1), remove the output shaft seal (2) from the transfer case (2). See Fig 3.