LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (42RLE Automatic Transmission (Service Information)) >> Service Information >> Sensor-Output Speed >> Removal

Sensor-Output Speed: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Input and Output Speed Sensors and Transmission Range Sensor
GC0012854Courtesy of DAIMLERCHRYSLER CORP.
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - TRANSMISSION RANGE SENSOR
  1. Raise vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the output speed sensor (2). See Fig 1.
    NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
  4. Remove the bolt holding the output speed sensor (2) to the transmission case.
  5. Remove the output speed sensor (2) from the transmission case.
scientia non olet · About LEMON Manuals