Hydraulic Pressure Tests: Notes

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressure Taps

Courtesy of DAIMLERCHRYSLER CORP.

1 - TORQUE CONVERTER CLUTCH OFF

2 - REVERSE

3 - LOW/REVERSE

4 - 2/4

5 - UNDERDRIVE

6 - TORQUE CONVERTER CLUTCH ON

7 - OVERDRIVE

Pressure testing is a very important step in the diagnostic procedure. These tests usually reveal the cause of most transmission problems.

Before performing pressure tests, be certain that fluid level and condition, and shift cable adjustments have been checked and approved. Fluid must be at operating temperature (150 to 200 degrees F.).

Install an engine tachometer, raise vehicle on hoist which allows the wheels to turn, and position tachometer so it can be read.

Using special adapters L-4559, attach 300 psi gauge(s) C-3293SP to the port(s) required for test being conducted.

Test port locations are shown in the Pressure Taps graphic. See Fig 1.