LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (42RLE Automatic Transmission (Service Information)) >> Service Information >> Assembly-Transmission Solenoid/Pressure Switch >> Removal

Assembly-Transmission Solenoid/Pressure Switch: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the Solenoid/Pressure Switch Assembly is being replaced, the Quick Learn Procedure must be performed. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD PROCEDURE)
Fig 1: Solenoid Retaining Screws
GC0009592Courtesy of DAIMLERCHRYSLER CORP.
1 - SOLENOID/PRESSURE SWITCH ASSEMBLY
2 - RETAINING SCREWS
  1. Raise vehicle on hoist.
  2. Remove valve body assembly from transmission. (Refer to TRANSMISSION/AUTOMATIC - 42RLE/VALVE BODY - REMOVAL) 
  3. Remove Solenoid/Pressure Switch Assembly retaining screws (2) from solenoid. See Fig 1.
    Fig 2: Solenoid/Pressure Switch Assembly and Screen
    GC0009593Courtesy of DAIMLERCHRYSLER CORP.
    1 - SOLENOID/PRESSURE SWITCH ASSEMBLY
    2 - VALVE BODY
    3 - SCREEN
  4. Remove Solenoid/Pressure Switch Assembly (1) and screen from valve body (2). See Fig 2.
scientia non olet · About LEMON Manuals