LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Nag1 Automatic Transmission (Service Information)) >> Service Information >> Unit-ELECTROHYDRAULIC Control >> Removal

Unit-ELECTROHYDRAULIC Control: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Wiring Connector Plug
GC0012698Courtesy of DAIMLERCHRYSLER CORP.
1 - PLUG CONNECTOR
2 - ADAPTER PLUG
  1. Move selector lever to position "P".
  2. Raise vehicle.
  3. Disconnect 13-pin plug connector (1). See Fig 1. Turn bayonet lock of the adapter plug (2) anti-clockwise.
    Fig 2: Removing/Installing Electrohydraulic Unit
    GC0012712Courtesy of DAIMLERCHRYSLER CORP.
    1 - HEAT SHIELD
    2 - ELECTROHYDRAULIC UNIT
    3 - BOLT
    4 - OIL FILTER
    5 - OIL PAN
    6 - CLAMPING ELEMENT
    7 - BOLT
    8 - 13-PIN PLUG CONNECTOR
    9 - BOLT
    10 - ADAPTER PLUG
  4. Loosen the adapter plug bolt (9) and remove from the adapter plug (10) from the transmission housing. See Fig 2.
  5. Detach oil pan (5).
  6. Remove oil filter (4).
  7. Unscrew Torx socket bolts (3) and remove electrohydraulic control module (2).
scientia non olet · About LEMON Manuals