LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Nag1 Automatic Transmission (Service Information)) >> Service Information >> K3-Input Clutch >> Disassembly

K3-Input Clutch: Disassembly

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input Clutch K3 Components
GC0012814Courtesy of DAIMLERCHRYSLER CORP.
1 - SNAP-RING 6 - PISTON
2 - MULTIPLE DISC PACK 7 - SEALING RING
3 - DISK SPRING 8 - OUTER DISC CARRIER
4 - SNAP-RING 9 - MULTI-USE SPRING COMPRESSOR 8900
5 - SPRING PLATE
  1. Remove snap-ring (1) from outer multiple-disc carrier. See Fig 1.
  2. Remove multiple-disc pack (2) and disk spring (3) from outer multiple-disc carrier. Note which clutch disc is removed just prior to the disc spring (3) for re-assembly. If the clutch discs are re-used, this disc must be returned to its original position on top of the spring plate.
  3. Place Multi-use Spring Compressor 8900 (9) on the spring plate (5) and compress the spring until the snap-ring (4) is exposed. See Fig 1.
  4. Remove snap-ring (4).
  5. Remove spring plate (5) and piston (6) from outer multiple-disc carrier.
scientia non olet · About LEMON Manuals