LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Nag1 Automatic Transmission (Service Information)) >> Service Information >> GEARTRAIN-Planetary >> Disassembly

Service Information: GEARTRAIN-Planetary: Disassembly

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Output Shaft With Center and Rear Planetary Geartrain
GC0012826Courtesy of DAIMLERCHRYSLER CORP.
1 - TEFLON RINGS 7 - DRIVING CLUTCH K3
2 - OUTPUT SHAFT WITH CENTER PLANETARY CARRIER 8 - THRUST WASHER
3 - NEEDLE BEARING 9 - AXIAL NEEDLE BEARING
4 - THRUST WASHER 10 - SHIM
5 - REAR PLANETARY GEAR SET 11 - RETAINING RING
6 - REAR HOLLOW SHAFT/FREEWHEELING CLUTCH F2
  1. Remove upper two visible Teflon rings (1) from output shaft. See Fig 1.
  2. Remove retaining ring (11), shim (10), thrust needle bearing (9) and thrust washer (8) from output shaft.
  3. Remove clutch K3 (7).
  4. Remove rear tubular shaft/freewheeling clutch F2 (6) from output shaft. See Fig 1.
  5. Remove rear gear set (5) with integrated tubular shaft of center gear set from output shaft.
  6. Remove thrust washer (4).
scientia non olet · About LEMON Manuals