Section 14 (Wiper System & Washer System (Service Information)): Sensor-Rain: Removal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Disconnect the electrical connector.
- Using a small screwdriver or equivalent, from the top (connector side) push in the tabs until the slider protrudes from the opposing (bottom) side of the sensor case.
- Gently pull each slider (1) slightly more until the cam lock releases the sensor.