Section 14 (Wiper System & Washer System (Service Information)): Sensor-Rain: Installation
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure that the slider locks are positioned correctly in the downward position, sticking out of the side opposite the connector.
- Position the rain sensor below the inside rear view mirror, over the bracket and gently push down to seat it on the bracket.
- Push the slider cam locks (1) inward until they are flush with the side of the sensor case.
- Connect the wire harness connector to the sensor.
- Connect the battery negative cable.