Headlamp Washer Hose: Removal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
The headlamp washer hose (2) is a special high pressure hose with specific fittings (3), and must be replaced as a unit.
- Disconnect and isolate the battery negative cable.
- Loosen up the fascia (1) on the side of the vehicle in which hose needs replacing (Refer to FRAME & BUMPERS/BUMPERS/FRONT FASCIA - REMOVAL) .
- When disconnecting hose (2) , press down firmly on latch (3) at headlamp washer pump motor and washer assembly and pull apart.