Headlamp Washer Hose: Installation
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
The headlamp washer hose is a special high pressure hose with specific fittings, and must be replaced as a unit.
- Install the new high pressure headlamp washer hose (2) assembly. Push fitting (3) on until a snap is heard.
- Install the fascia (Refer to FRAME & BUMPERS/BUMPERS/FRONT FASCIA - INSTALLATION) .
- Connect the battery negative cable.