LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Power Top - Convertible (Service Information)) >> Relay-Power Top >> Removal

Relay-Power Top: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Motor/Hydraulic Pump Assembly
GC0022972Courtesy of DAIMLERCHRYSLER CORP.
  1. Start with the folding top in the raised and latched position.
  2. Disconnect and isolate the battery negative cable.
  3. Remove the rear seat back, (Refer to BODY/SEATS/SEAT BACK - REMOVAL) .
  4. Remove the well liner/carpet from the power top well.
  5. Remove the foam pump cover from over the motor/hydraulic pump.
  6. Disconnect the motor/hydraulic pump relay wire harness connector (3).
  7. Depress the relay retaining tab and remove the relay (2) from the bracket.
scientia non olet · About LEMON Manuals