LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Emissions Control System) >> Exhaust Gas RECIRCULATION Valve >> Tube-Exhaust Gas RECIRCULATION >> Installation >> 2.7L - Upper Tube

2.7L - Upper Tube

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR Valve And Tubes
GC0014027Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean mounting surface.
  2. Inspect rubber silicone seals on intake manifold end of EGR tube.
  3. Install upper tube into the intake manifold, being careful that the silicone rubber seals are correctly installed and undamaged.
  4. Install new gasket between the EGR valve and tube and install bolts (2).
  5. Tighten the upper tube to EGR valve bolts to 11 N.m (95 in. lbs.) torque.
    Fig 2: Purge Solenoid Bracket
    GC0014017Courtesy of DAIMLERCHRYSLER CORP.
  6. Connect the electrical connector to EGR valve and lock.
  7. Relocate the purge solenoid.
    Fig 3: Purge Solenoid Installed
    GC0014018Courtesy of DAIMLERCHRYSLER CORP.
  8. Install purge solenoid to bracket.
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals