LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Emissions Control System) >> Exhaust Gas RECIRCULATION Valve >> Tube-Exhaust Gas RECIRCULATION >> Installation >> 2.7L - Lower Tube

2.7L - Lower Tube

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR System
GC0014026Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean mounting surface.
    Fig 2: EGR Valve And Tubes
    GC0014027Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the lower tube to vehicle.
  3. Install the lower tube bolts to EGR valve.
  4. Install the lower tube bolts to exhaust manifold.
  5. Tighten the lower tube to EGR valve bolts to 11 N.m (95 in. lbs.) torque.
  6. Tighten the lower tube to exhaust manifold bolts to 31 N.m (275 in. lbs.) torque.
    Fig 3: Purge Solenoid Bracket
    GC0014017Courtesy of DAIMLERCHRYSLER CORP.
  7. Connect the electrical connector to EGR valve and lock.
  8. Relocate the purge solenoid.
    Fig 4: Purge Solenoid Installed
    GC0014018Courtesy of DAIMLERCHRYSLER CORP.
  9. Install purge solenoid to bracket.
  10. Connect negative battery cable.
scientia non olet · About LEMON Manuals